Rediscovering the clarinet’s left-hand sliver key

by

I think for many doublers the clarinet’s left-hand “sliver” key seems useless or problematic. For example, the sliver key is easy to press by mistake when intending to cover the middle and/or ring finger holes. And even when reaching for the sliver on purpose, it’s easy to accidentally cover part of the ring finger hole, producing an E-flat or B-flat that is flat and stuffy.

The left-hand sliver also lacks any real analogue on any of the other common woodwinds, so its use is a technique that doesn’t transfer easily from another instrument. Flutes, saxophones, and standard bassoons don’t have any key in that spot. The oboe has a trill key there, but its usage isn’t similar. Among the standard band/orchestral woodwinds, only the contrabassoon has a key positioned here that is used in a similar way to the clarinet family. Especially for saxophonists, the right-side fingering is much more familiar.

The Woodwind Fingering Guide (still the best fingering source on the web) lists three E-flat/B-flat fingerings in its standard clarinet fingering chart, with only the right-side-key fingering marked as “basic.” The left-hand-sliver fingering is described as a “Chromatic and trill fingering,” to “use in combination with D4 [D below the staff] and A5 [A above the staff].” (The “one and one” fingering using both index fingers is also listed, though it might perhaps be better relegated to the “alternate” fingering chart.)

Occasionally I’ve run across the attitude that the sliver key could perhaps be removed or wedged shut to prevent accidental venting. I think this would be a waste, and all clarinetists of an intermediate level or higher should get used to using this key as an equal partner with the right hand key—not merely as an alternative for rare occasions.

Here are a couple of examples from well-known solo repertoire where the left-hand sliver makes sense:

Read more

Full-range scales and arpeggios

by

My students at the university are subject to a department-wide requirement to pass a scale exam, in which they must demonstrate mastery of major and minor scales. The format of the scales, however, is left up to the individual studio professors.

Most of the studios require scales to be played in octaves, but I prefer a different approach. To the chagrin of my students (oboists/clarinetists/bassoonists/saxophonists), I require that they are played in this format:

  1. Start on the first scale degree, in the instrument’s lowest octave.
  2. Proceed upward in an even rhythm (such as even eighth notes) to the highest note in the instrument’s “range” that falls within the scale (according to an upper range limit that I set).
  3. Proceed downward to the instrument’s lowest note that falls within the scale.
  4. Proceed back upward to the starting note.

So, for example, an oboe student’s E-flat major scale goes like this:

I also require arpeggios, following the same rules:

Here is why I insist on full-range scales:

Read more

Flute Pro Shop interview with Tereasa Payne and Simon Hutchings

by

There’s a nice interview by Joan Sparks at the Flute Pro Shop blog, with two woodwind doublers who happen to be married to each other, Tereasa Payne and Simon Hutchings. They discuss doubling, careers, and married life. I can’t imagine being in a marriage with anyone other than a musician. Everyone makes sacrifices for what … Read more

Evaluating reeds

by

Photo, chelseagirl There are three things to consider when evaluating a reed. I consider these same factors for either single or double reeds, and prioritize them in this order. Response. The overriding concern for me is that the reed responds exactly as I expect it to. A reed that is stiff, sluggish, stuffy, or otherwise … Read more

University of Northern Iowa offers new multiple woodwinds degree

by

The University of Northern Iowa is now offering a Master of Music degree with a multiple woodwinds (3-instrument) emphasis. A few points of interest, according to degree information from their website: Students take 6 credit hours of study on a “primary” instrument, and 4 hours on a “secondary” instrument, and must “demonstrate proficiency” on a … Read more

Balancing voicing and breath support

by

My oboe students frequently have this problem: These notes don’t respond well These notes are sharp and thin-sounding (Okay, sometimes I also have this problem.) The solution, in most cases, is quite simple. Step 1: Use the correct voicing. For oboe it should be low and open, like blowing very warm air. This is usually … Read more

Internet forum field guide: gear recommendations

by
Enter with caution.

If you frequent any of the various woodwind-related Internet message boards, forums, or listservs, you have undoubtedly encountered some of the wildlife I will describe here. Remember that they can be dangerous creatures, and that it is often best not to attempt interaction with them.

One of the most common animal behaviors witnessed on the message boards is the exchange of gear recommendations. There are two primary families of wildlife the participate in this ritual: the askers and the answerers.

The askers

The askers all share a common behavioral trait: a proclivity for asking total strangers to blindly recommend instruments, mouthpieces, reeds, and other items. Their calls are varied.

Some prefer to remain hidden in the underbrush, offering no clarifying details:

hey guys first time on this board what reedz should I use lolz

Read more

Ernie Watts on not doubling

by

Check out this blog post by Helen over at the Bassic Sax blog for some thoughts from saxophone great Ernie Watts about the downside of doubling. At some point, you end up in a mush of mediocrity. Go read it

A toolkit for simple woodwind repairs

by

I think it’s really valuable to be able to do a few small repairs on woodwind instruments. As a doubler, I’ve found it to be a financial necessity—I can’t afford to run to the repair shop every time some little thing needs tweaking on one of my instruments—and it’s a great way to get to … Read more

Jazz chord symbols: a primer for the classically-trained

by

Printed jazz music often uses chord symbols to indicate the music’s underlying harmony. As with the Roman numeral system used in classical music theory, jazz chord symbols may be used as a tool for analysis. But they are also used for performance, like Baroque figured bass notation, with the musicians using the symbols as a framework for improvising melodies and/or accompaniments. In jazz, the symbols are  generally non-specific with respect to inversion, and players of chord-capable instruments (such as piano or guitar) in jazz are accustomed to making independent choices about inversion and voicing. Depending on the situation, printed jazz music may include written notes only, or notes plus chord symbols, or even chord symbols alone.

Simple major triads aren’t common in most “modern” (post-1940) jazz. But in the rare cases that they do appear, they are indicated with a single note name:

jazz chord symbol: simple triad
C major

The letter “C” above the staff is the chord symbol. The notes shown on the staff here are the corresponding pitch classes, stacked in root position in the thirds familiar to students of classical theory, though a jazz musician, composer, or arranger would rarely voice a chord in this way.

Almost always, there should some variety of seventh specified, using the numeral 7 (and when it isn’t specified, it is often implied). By convention, using the 7 alone with a note name indicates the lowered seventh:

jazz chord symbol: seventh
C seventh

Read more